RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
NOTE: Verify seal is fully seated and not twisted.
2. Install new piston seals (2) into caliper bores (1).
3. Leave boot (1) dry and slip onto end of piston (2).
NOTE: The dust boot lip must be inserted before the piston
4. Slightly pull out lip portion of piston boot (3) so it protrudes past the bottom of the piston (2) and work lip into outermost groove on caliper
housing (1).
5. Carefully press the lip (3) into the groove with a suitable tool (4) Avoid using sharp-edged tools This will ensure that the lip is nested into the
groove all around before pushing the piston into the bore.