RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
area of repair instead of the entire system.
2. Raise and support vehicle.
3. Remove the wheel and tire assembly.
4. Drain small amount of fluid from master cylinder brake reservoir with suction gun.
5. Remove the brake hose banjo bolt and discard the copper washers if replacing caliper.
6. Remove the caliper slide bolts (3).
7. Remove the caliper (6) from vehicle.
Light Duty
FRONT - LIGHT DUTY
NOTE: Petroleum based grease should not be used on any of the rubber components of the caliper, Use only Non-Petroleum based grease.
NOTE: Clean slide pin bores thoroughly to remove any old grease.
NOTE: Use grease packets included with kit or Dow Corning-807(R) grease.
1. Thoroughly coat the new slide pins (3) on all working surfaces.
2. Install the boot (2) onto the slide pin (3) and then insert into the adapter (1).
3. Push the pin (3) all the way into the adapter (1) and carefully expel the trapped air by gently pushing on the boot (2) near the slide pin head (3).
4. Install the disc brake caliper (1) to the brake caliper adapter (2).
