RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Installation
Front
INSTALLATION
1. Install the wiring to the clips and connect the electrical connector.
2. Install the wheel speed sensor (2) to the hub (3).
3. Install the wheel speed sensor mounting bolt (1) to the hub (3). For 1500, tighten to 21 Nm (190 in. lbs.). For 2500/3500, tighten to 13 Nm (115
in. lbs.).
4. Install the front rotor and brake caliper assembly See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Brake
Rotor - Installation.
Rear
2500/3500
1. Connect the harness to the sensor. Be sure the seal is securely in place between the sensor and the wiring connector.
2. Install the O-ring on the sensor (if removed).
3. Insert the sensor (1) in the differential housing (3).
4. Install the sensor shield.
5. Install the sensor mounting stud (2) and tighten to 24 Nm (200 in. lbs.).
