RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
7. Install the the fan shroud-to-lower radiator shroud push pins.
8. Install the fan shroud-to-radiator shroud mounting bolt (2) located on the passenger side of the vehicle. Tighten the bolt (2) to 24 Nm (18 ft. lbs.).
9. Install the two fan shroud-to-radiator shroud mounting bolts (3) located on the driver side of the vehicle. Tighten the bolts (3) to 24 Nm (18 ft.
lbs.).
10. Position and connect the fan drive wire harness support (1) to the fan shroud.
11. Connect the electronically controlled viscous fan electrical connector (2) at the fan shroud.
12. If equipped, connect the negative battery cable to the auxiliary battery.
13. Connect the negative battery cable.
14. Install the upper radiator shroud (1).
NOTE: Viscous Fan Drive Fluid Pump Out Requirement: After installing a new viscous fan drive, bring the engine speed up to approximately
2000 rpm and hold for approximately two minutes. This will ensure proper fluid distribution within the drive.
