RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
1. If previously removed, install the push rods in their original location. Verify that they are seated in the tappets.
2. Lubricate the valve tips and install the crossheads in their original locations.
3. Lubricate the crossheads and push rod sockets and install the rocker arms and pedestals in their original locations. Tighten bolts to 36 Nm (27 ft.
lbs.).
4. Verify valve lash adjustment See: Valve/Service and Repair/Procedures.
5. Install cylinder head cover See: Valve Cover/Service and Repair/Removal and Replacement/Cylinder Head Cover(s) - Installation.
6. Connect both negative battery negative cables.
