RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
CAUTION: When installing rocker housing onto cylinder head, do not slide housing from side to side, The gasket could fall out or be damaged.
3. Install the rocker housing. Carefully guide the rocker housing evenly down onto the cylinder head.
4. Install rocker housing bolts and tighten finger tight.
5. Tighten bolts, working from center out, to 24 Nm (18 ft. lbs.).
Cylinder Head Cover
CYLINDER HEAD COVER
NOTE: Gasket must be completely dry and free of oil before installation. Pneumatic tools should NOT be used to remove or install the cover.
1. Wipe oil from the cylinder head cover gasket (2), rocker box, and cylinder head cover.
2. Inspect cylinder head cover gasket (2) for tears, or splits. Replace if necessary.
3. Install the cylinder head cover gasket (2) on the rocker box.
4. Install the injector nuts to injector studs. Tighten nuts to 1.25 Nm (11 in. lbs.).
5. Connect both injector harness connectors.
NOTE: Pneumatic tools should NOT be used to remove or install the cover.
6. Install cylinder head cover and cylinder head cover capscrews. Tighten from center out. Tighten to 24 Nm (18 ft. lbs.).