RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
13. Connect the negative battery cables.
14. Fill the crankcase with new engine oil.
15. Start engine and check for leaks. Stop engine, check oil level, and adjust, if necessary.
NOTE: Make sure that the fan shroud seal is properly seated in the radiator fan shroud and that it is not out of position causing excessive
contact with the radiator coolant tubes.
16. Install the fan and fan shroud. See: Cooling System/Radiator Cooling Fan/Service and Repair/Electric Radiator Fan - Installation
4x2
1. Clean the sealing surfaces of the cylinder block and oil pan with a suitable cleaner.
2. Clean the oil pan.
3. Clean the oil pan T-joints.
4. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar(R) Silicone Rubber Adhesive Sealant or
equivalent.
5. Position the new oil pan gasket.
