RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
6. Remove the front suspension track bar.
7. Remove the right and left engine mount through bolt.See: Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and
Repair/Engine Mount Insulator - Removal
8. Remove the steering gear retaining bolts.See: Steering and Suspension/Steering/Steering Gear/Service and Repair/Steering Gear - Installation
9. Drain the engine oil.
10. Lower the vehicle.
11. Install the engine lift fixture.
12. Use the engine lift fixture to raise the engine.
13. Raise the vehicle on the hoist.
14. Remove the oil pan retaining bolts.
15. Lower the oil pan enough to allow the removal of the oil pan gasket.
16. Remove the oil pan gasket.
