RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
2. Position differential pressure sensor (1).
3. Install mounting nuts (5) and bolts. Tighten to 10 Nm (89 in. lbs.).
NOTE: Before installing, inspect both pressure hoses and make sure there is not any dip across the hoses. In cases where water is frozen, a dip
across the hoses can cause condensation which can set a MIL.
4. Install hose (2) to the rear DPF tubing.
5. Install hose (3) to the front DPF tubing.
6. Connect electrical connector (6).
7. Lower vehicle.
