RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Air Register: Service and Repair
Air Outlet - Removal
Front Center Air Outlets
FRONT CENTER AIR OUTLETS
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: Take the proper precautions to protect the front face of the center bezel from cosmetic damage during this procedure.
1. Disconnect and isolate the negative battery cable.
2. Remove the center bezel (1) from the instrument panel and place it on a workbench See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Instrument Panel Bezel - Removal.
3. Using Trim Stick C-4755 (2) or equivalent, carefully disengage the eight plastic retaining clips (4) that secure each air outlet (3) to the center
bezel.
4. Lift the top of each air outlet (1) rearward and upward to disengage the bottom of each outlet from the center bezel (2) and remove the outlet(s).
Front Outer Air Outlets
FRONT OUTER AIR OUTLETS
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
