RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
k. Remove the center stack lower trim panel (Figure 7).
l.
Remove the two bolts that secures the instrument panel to the center of the floor panel.
m. Remove the right "A" pillar trim panel (grab handle) and disconnect the headliner wire harness connector.
n. Using a trim stick (C-4755 or equivalent) remove the right instrument panel side cover and remove the three bolts that secure the right side
instrument panel to the dash panel.
o. Remove the right side kick panel and disconnect the three instrument panel wiring harness connectors from the two body wiring harness
connectors.
p. Disconnect the antenna coaxial cable from the radio coaxial cable connector.
q. Remove the two fence line bolt access covers and then remove the two fence line bolts.
r.
Remove the Occupant Restraint Controller (ORC) module black plastic cover (Figure 8).
s. Disconnect the ORC module left yellow electrical connector and remove the wire from under the carpet (Figure 8).
t.
With the help of an assistant, lift the instrument panel up and off of the cowl panel and set the instrument panel face-down on the vehicle carpet.
4. Continue with Step 5 to replace the recirculation door actuator and/or Step 6 to replace the right temperature actuator (ATC only).
