RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Solar Sensor: Service and Repair
Sun Sensor - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. Remove the trim panel (2) that contains the sun sensor (1) from the top of the instrument panel using Trim Stick C-4755 or equivalent and
disconnect the instrument panel wire harness connector from the sensor.
3. Using Trim Stick C-4755 or equivalent, gently pry on both sides of the sun sensor assembly and remove the sun sensor from the panel.
