RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Glove Box Lamp: Service and Repair
Glove Box Lamp Bulb - Removal
BULB
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Open the upper glove box door.
3. Reach through the window (3) in the upper glove box bin (1) to access the bulb located in the bulb holder integral to the glove box lamp and
switch unit (2).
4. Pull the base of the bulb straight out of the bulb holder and through the bin window.
