RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
NOTE: After setting toe to specifications, normalization of the tie rod to knuckle must be verified to be sure that the adjustments are correct.
7. For 2500/3500, to normalize, venfy the lower surface of the outer tie rod socket (2) is parallel to the upper surface ofthe knuckle (1). Rotate the
drag link/tie rod until ball joint to knuckle is parallel.
NOTE: Toe setting may change during tightening, Make sure to verify reading after tightening.
8. Verify the steering wheel is straight and the toe settings are correct (repeat steps 2-6 if necessary).
9. Road test the vehicle.
