RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Accelerator Pedal Position Sensor: Service and Repair
Removal
REMOVAL
CAUTION: Do not attempt to separate or remove the Accelerator Pedal Position Sensor (APPS) from the accelerator pedal assembly. The
APPS and the accelerator pedal is replaced as an assembly. If the sensor is removed from the pedal, the electronic calibration may
be destroyed.
1. Disconnect 6-way electrical connector at top of APPS (2).
2. Remove APPS lower mounting bolt (4) and two mounting nuts.
3. Remove pedal and APPS assembly from vehicle.
