RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
2. Connect the wiTECH VCI pod to the vehicle data link connector located under the steering column.
3. Place the ignition in the "RUN" position.
4. Open the wiTECH Diagnostic application.
5. Starting at the "Select Tool" screen, select the row/tool for the wiPOD device you are using.
6. Enter your "User id" and "Password", then select "OK".
7. Select the "Next" tab at the bottom of the screen.
8. From the "Vehicle View" screen, click on the PCM icon.
9. From the "PCM View" screen, compare the "Current ECU Flash Number" with the "New Part Number" listed on the "sort table". If the "Current
ECU Flash Number" is the same as the "New Part Number" continue to Step 23. If the part numbers are not the same, continue to Step 10.
10. With the cursor over the desired flash file, click the small green arrow button on the right side of the screen.
11. From the "ECU Flash" screen follow the wiTECH screen instructions to complete the flash.
12. Once the flash is complete click the "OK" button on the "ECU Flash" screen.
13. Turn the ignition to the "OFF" position for 10 minutes.
14. Set the parking brake.
15. Start the engine.
16. Select "Misc Function" from the "PCM View" screen.
17. Select "Quick Learn", then click the small green arrow button on the right side of the screen.
18. From the "Quick Learn" screen follow the wiTECH screen instructions to complete the transmission quick learn procedure.
19. Once the transmission quick learn procedure is completed, select "Vehicle View" from the "PCM View" screen.
20. From the "All DTC's" tab, select the "Clear Stored DTC's" button.
21. Select "OK" from the pop-up text box.
22. From the "PCM View" screen, compare the "Current ECU Flash Number: with the "New Part Number" listed on the "sort table". If the "Current
ECU Flash Number" is the same as the "New Part Number" the flash is complete. If the part numbers are not the same, repeat Steps 8 through 22.
23. Turn the ignition to the "OFF" position, remove the wiPOD and battery charger from the vehicle.
24. Continue with Section C. Install Authorized Modifications Label.
B. Reprogram the ECM - Manual Transmission Equipped Vehicles
1. Open the hood. Install a battery charger and verify that the charging rate provides 13.0 to 13.5 volts. Do not allow the charger to time out during the
flash process. Set the battery charger timer (if so equipped) to continuous charge.
NOTE:
Use an accurate stand alone voltmeter. The battery charger volt meter may not be sufficiently accurate. Voltages outside of the specified range
will cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC blower
motor to lower the voltage.
2. Connect the wiTECH VCI pod to the vehicle data link connector located under the steering column.
3. Place the ignition in the "RUN" position.
4. Open the wiTECH Diagnostic application.
5. Starting at the "Select Tool" screen, select the row/tool for the wiPOD device you are using.
