RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
5. Remove the four WIN mounting screws that secure the WIN to the instrument panel support structure, (Figure 8).
6. If equipped, disconnect the remote start system antenna module coaxial cable connector from the WIN connector receptacle.
7. Disconnect the instrument panel wire harness connector from the WIN connector receptacle.
8. Remove the WIN from the instrument panel.
9. Position the new WIN to the instrument panel.
10. Connect the instrument panel wire harness connector to the WIN connector receptacle.
11. If equipped, connect the remote start system antenna module coaxial cable connector to the WIN connector receptacle.
12. Install and tighten the four screws that secure the WIN to the instrument panel support structure. Tighten the screws securely.
13. Position the bezel around the ignition switch on the instrument panel, then press firmly and evenly on the bezel until it snaps into place.
14. Install the knee bolster onto the instrument panel.
15. Install the cluster bezel onto the instrument panel.
16. Connect the battery negative cable.
17. Continue with Section E. Obtaining Vehicle Personal Identification Number (PIN).
E. Obtaining Vehicle Personal Identification Number (PIN)
1. Log onto the DealerCONNECT system.
2. Click on the "PARTS" tab.
3. In the "Reference Library" box, select "KEY CODE".
4. Enter the last eight digits of the Vehicle Identification Number (VIN).
5. Enter the requested data on the screen to obtain the key code.
6. Write down the PIN and then continue with Section F. Program the WIN Receiver.
F. Program the WIN Receiver
The secret key is an ID code that is unique to each WIN. This code is programmed and stored in the WIN, the PCM, and each ignition key transponder
chip. When the WIN is replaced, it is necessary to program the Secret Key Code into the new module using a diagnostic scan tool.
NOTE:
Programming the WIN is done using a diagnostic scan tool and the vehicle's PIN to enter secure access mode. If three attempts are made to enter
secure access mode using an incorrect PIN, secure access mode will be locked out for one hour.
