RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
1. Disconnect the negative battery cable.
2. Remove the center bezel using the following procedure:
a. Remove the center bezel tray liner (Figure 2).
b. Remove the power outlet trim bezel.
c. Remove the three center bezel mounting screws.
d. Unsnap the center bezel from the instrument panel, disconnect the electrical connectors and remove the center bezel.
3. Remove the cup holder using the following procedure:
a. Remove the lower cup holder trim panel.
b. Remove the six cup holder mounting screws.
c. Remove the cup holder assembly and side panels.