RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
1. Adjust the front seat to its most forward position for easiest access to the front seat belt lower anchor (3) and the lower B-pillar trim.
2. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
3. On the passenger side only, remove the trim cover from the front seat riser as necessary to access the front seat belt lower anchor. See: Body and
Frame/Seats/Service and Repair.
4. Remove the screw (2) that secures the lower anchor (3) to the floor panel (4) near the base of the B-pillar (1).
5. Firmly grasp the top of the trim cover (3) for the front seat belt turning loop height adjuster (1) on the inside of the upper B-pillar and pull it away
from the height adjuster far enough unsnap it, then disengage the lower snap features of the trim cover from the adjuster and discard. The trim
cover is a one time component and is not intended for reuse.
6. Remove the screw (4) that secures the seat belt turning loop (5) to the height adjuster on the upper B-pillar.
7. Remove the seat belt turning loop from the height adjuster.
8. Remove the lower trim from the inside of the B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel - Removal.
