RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Seat Belt Retractor: Service and Repair
Seat Belt Retractor - Installation
Center - Standard Cab
CENTER - STANDARD CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
NOTE: A front center three-point seat belt and retractor is used only on standard cab vehicles. Quad or crew cab and mega cab vehicles with
a front bench seat have a two-point lap belt in the front center seating position. See: Seat Belt Buckle/Service and Repair/Seat Belt
Buckle - Installation .
NOTE: All seat belt retractors except the driver side front retractor include a switchable automatic locking mechanism. See: Description and
Operation/Seat Belt Retractor - Description .
1. Position the front center seat belt and retractor unit (5) to the floor panel (6) at the base of the cab back panel (8) to the right of center.
2. Install and tighten the two screws (4) that secure the front center seat belt retractor bracket to the floor panel near the base of the cab back panel.
Tighten the screws to 39 Nm (29 ft. lbs.).
3. Position the belt bracket (2) of the front center seat belt (7) to the body bracket (1) on the upper cab back panel reinforcement.
4. Install and tighten the two screws (3) that secure the belt bracket of the front center seat belt to the body bracket on the upper cab back panel
reinforcement. Tighten the screws to 20 Nm (15 ft. lbs.).
