RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
9. Position the seat belt turning loop (5) onto the height adjuster (1) on the upper B-pillar. Be certain that the seat belt webbing between the web
guide and the turning loop is not twisted.
10. Install and tighten the screw (4) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
11. Position a new trim cover (3) over the top of the turning loop, then snap it into place. Engage the lower snap features first, then the upper snap
features. The trim cover is a one time component and is not intended for reuse.
12. Position the seat belt lower anchor (4) to the mounting hole near the base of the inner B-pillar (1). Be certain that the seat belt webbing between
the turning loop and the lower anchor is not twisted.
13. Install and tighten the screw (3) that secures the lower anchor to the B-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
14. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Service and Repair.
Rear Center - Quad or Crew Cab
REAR CENTER - QUAD OR CREW CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
NOTE: The rear center seat belt and retractor is secured to a mounting bracket that includes the right outboard occupant seat belt buckle.
