RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Engine Coolant Temperature Sensor - Removal
6.7L DIESEL
WARNING: Hot, pressurized coolant can cause injury by scalding. Cooling system must be partially drained before removing the coolant
temperature sensor.
1. Partially drain the cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
2. Remove the engine trim cover.
3. Remove the upper EGR tube (2).See: Powertrain Management/Emission Control Systems/Exhaust Gas Recirculation/EGR Tube/Service and
Repair/Exhaust Gas Recirculation (EGR) Tube - Removal
4. Remove heat shield.
5. Disconnect the electrical connector (2) from the ETC sensor (3).
6. Remove the ETC sensor from the cylinder head.
