RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Remove the trim panel from the inside of the right or left front door. See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door
Panel/Service and Repair/Front Door Trim Panel - Removal.
3. Disconnect the front door module wire harness connector (3) from the side impact sensor (1) connector receptacle.
4. Remove the two screws (4) that secure the sensor to the front door module carrier panel (2).
5. Remove the side impact sensor from the front door.
B-PILLAR - STANDARD CAB
1. Adjust the driver or passenger side front seat to its most forward position for easiest access to the B-pillar trim.
2. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
3. Remove the trim from the inside of the lower B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel - Removal.
4. Disconnect the body wire harness connector (1) from the side impact sensor (2) connector receptacle.
5. Remove the screw (3) that secures the sensor to the inner B-pillar.
6. Remove the sensor from the inner B-pillar.
B-PILLAR - EXCEPT STANDARD CAB
