RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Ball Joint: Service and Repair
Front Suspension Upper Ball Joint - Installation
INSTALLATION
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure
proper operation during the removal and installation process.
1. Install the ball joint (3) into the upper control arm (4) and press in using Ball Joint Press C-4212F (1), Ball Joint Installer 9652 (2) and Installer
8445-1 (5).
2. Install the upper ball joint into the knuckle.
3. Install the upper ball joint retaining nut and tighten to 54 Nm (40 ft. lbs.) then add an additional 90° turn.
4. Install the wheel speed sensor wire to the upper control arm.
5. Install the tire and wheel.
6. Remove the supports and lower the vehicle.
7. Perform a wheel alignment See: Alignment/Service and Repair.
