RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Control Module: Service and Repair
TCM Quick Learn
TCM QUICK LEARN - RLE AND RFE TRANSMISSIONS
The quick learn procedure requires the use of the scan tool. For scan tool step by step instructions, reference the ECM/PCM/TCM Programming
document, Quick Learn.
This program allows the electronic transmission system to recalibrate itself. This will provide the proper transmission operation. The quick learn
procedure should be performed if any of the following procedures are performed:
-
Transmission Assembly Replacement.
-
Transmission Control Module Replacement.
-
Engine Control Module Replacement or Reprogramming.
-
Solenoid Pack Replacement.
-
Clutch Plate and/or Seal Replacement.
-
Valve Body Replacement or Recondition.
To perform the Quick Learn Procedure, the following conditions must be met:
-
The brakes must be applied.
-
The engine speed must be above 500 rpm.
-
The throttle angle (TPS) must be less than 3 degrees.
-
The shift lever position must stay in PARK until prompted to shift to overdrive.
-
The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the scan tool indicates the procedure is complete.
-
The calculated oil temperature must be above 60° and below 200°.
