RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
4. Disconnect the WIN electrical connector.
5. If equipped, remove the WIN antenna connector.
6. Remove and discard the original WIN from the instrument panel opening.
7. Connect the WIN electrical connector to the new WIN receiver.
8. If equipped, connect the WIN antenna connector to the new WIN receiver.
9. Install the WIN receiver into the instrument panel.
10. Install the four WIN mounting screws and tighten securely (Figure 3).
11. Install the instrument panel knee bolster (Figure 1).
12. Connect the negative battery cable.
13. Continue with Section E. Obtaining Vehicle Personal Identification Number (PIN).
C. (LC/LX) Dodge Challenger/Charger & Chrysler 300 WIN Replacement
1. Disconnect the battery negative cable.
2. Remove the end cap trim panel (Figure 3).
3. Remove the two screws from the knee bolster (Figure 3).
4. Remove the knee bolster cover (Figure 3).
5. Remove the knee bolster steel reinforcement located behind the knee bolster cover.
6. Using a trim stick or equivalent, gently pry along the edge of the trim to remove the instrument cluster trim (Figure 3).
