RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
-
The circuit is not shorted to ground or the condition that originally caused the short may not be present at this time. Continue to measure the
resistance, wiggle the wire harness and connectors while checking for an intermittent short.
-
Use the wiring application as a guide to trace the circuits and look for any in-line connectors where the short could occur intermittently.
-
Look for any chafed, pierced, pinched, or partially broken wires.
-
Look for broken, bent, pushed out or corroded terminals. Verify that there is good pin to terminal contact in the related wire harness connectors.
-
Perform any Technical Service Bulletins (TSBs) that may apply.
Check A Circuit For Voltage
CHECK A CIRCUIT FOR VOLTAGE
Theory of Operation
The purpose for the following procedure is to show different methods of checking the voltage of a circuit. When diagnosing a DTCs it might be
necessary to verify that proper voltage is on a circuit or that a circuit is not shorted high. Below are four examples of checking the voltage in a circuit.
1. CHECKING FOR VOLTAGE
