RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Additional Information
If you have any questions or need assistance in completing this action, please contact your Service and Parts District Manager.
Customer Services Field Operations
Chrysler Group LLC
A. Inspect Win Receiver Operation (All Models)
1. Insert FOBIK in the WIN receiver.
2. Place the ignition in the "RUN" position.
3. Shift the gear shift lever from the "PARK" position to the "NEUTRAL" position.
4. With the gear shifter in the "NEUTRAL" position, attempt to turn the FOBIK counterclockwise to the "OFF" position and remove the FOBIK
from the WIN receiver.
>
If the FOBIK can be removed from the WIN receiver with the gear shift lever in "NEUTRAL," continue with one of the following sections:
>
B. (DS/DJ/D2) Ram 1500/2500/3500 Truck WIN Replacement
>
C. (LC/LX) Dodge Challenger/Charger & Chrysler 300 WIN
Replacement
>
D. (WK/XK) Jeep Grand Cherokee & Commander WIN Replacement
>
If the FOBIK cannot be removed with the gear shift lever in "NEUTRAL,"continue with Step 5 of this procedure.
5. Place the gear shift lever in the "PARK" position and remove the FOBIK from the WIN receiver.
6. Repeat Steps 1 through 4 of this procedure 49 times.
>
If the FOBIK can be removed while the gear shift lever is in the "NEUTRAL" position during any of the 50 test cycles, replace the WIN receiver.
>
If the FOBIK cannot be removed while the gear shift is in the "NEUTRAL" position after 50 test cycles, return the vehicle to the customer.
NOTE:
Only one FOBIK needs to be used to perform this test. There is no need to cycle test both FOBIK's 50 times.
B. (DS/DJ/D2) Ram 1500/2500 Truck WIN Replacement
1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel knee bolster (Figure 1).
3. Remove the four Wireless Ignition Node (WIN) receiver mounting screws (Figure 2).
