RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
6. Pry out hub bearing seal from the back of the hub.
NOTE: The inner part of the seal (3) may stay on the axle tube (2). This part must also be removed with a pry bar (1).
7. Remove rear bearing.
8. Remove hub bearing cups with a hammer and drift.
Installation
INSTALLATION
1. Install outer hub bearing cup with Installer 8961 and Handle C-4171.
2. Install inner hub bearing cup with Installer 8153 and Handle C-4171.
3. Pack bearings with the appropriate wheel bearing grease.
4. Install rear bearing and install new grease seal with Installer 8963 and Handle C-4171.
5. Slide hub on the axle tube and install front bearing into the hub.
6. Install hub bearing nut with Socket 8954 (1) and tighten with torque wrench (2) to 30 Nm (22 ft. lbs.) while rotating the hub.
7. Back off nut about 30° and align next hub nut key slot with axle tube key slot and install locking key.
NOTE: End play should be 0.025-0.25 mm (0.01-0.001 in.)
