RAM 2500 Truck 2WD L6-6.7L DSL Turbo (2010)
Axle Shaft: Service and Repair
Rear Axle - 11 1/2 AA
Removal
REMOVAL
1. Remove axle shaft flange (1) bolts (2).
2. Slide axle shaft out of the axle tube.
3. Remove axle shaft gasket.
Installation
INSTALLATION
NOTE: Axle flange bolts must be replaced or use Mopar(TM) Lock N' Seal or Loctite(R) 242 on cleaned existing bolts.
1. Clean axle flange and hub.
2. Install new axle shaft gasket.
3. Slide axle shaft into the axle tube.
4. Install axle shaft flange (1) bolts (2) and tighten to 129 Nm ( 95 ft. lbs.).
