RAM 2500 Truck 2WD V10-8.0L VIN W (2003)
NOTE: Make sure the output rod of the brake booster is in position before mounting of the master cylinder "This position will enable the output rod
to enter inside of the master cylinder plunger sleeve during installation". Proper position is obtained when the output rod is centered perpendicular to
the master cylinder mounting hole.
1. Install the master cylinder on the booster mounting studs.
2. Install new mounting nuts and tighten to 25 Nm (221 in. lbs.)
3. Install the brake lines and tighten to 19 Nm (170 in. lbs.)
4. Reconnect the electrical connector for the low fluid level switch.
5. Fill and bleed the base brake system.
