RAM 2500 Truck 2WD V10-8.0L VIN W (2003)
Parking Brake Cable: Service and Repair
Front Parking Brake Cable
REMOVAL - FRONT PARKING BRAKE CABLE
1. Raise and support vehicle.
2. Lockout the parking brake cable.
3. Loosen adjusting nut to create slack in front cable.
4. Remove the front cable from the cable connector.
5. Compress cable end fitting at underbody bracket and remove the cable from the bracket.
6. Lower vehicle.
7. Push ball end of cable out of pedal clevis with small screwdriver.
8. Compress cable end fitting at the pedal bracket and remove the cable.
9. Remove the left cowl trim and sill plate.
10. Pull up the carpet and remove the cable from the body clip.
11. Pull up on the cable and remove the cable with the body grommet.
INSTALLATION - FRONT PARKING BRAKE CABLE
1. From inside the vehicle, insert the cable end fitting into the hole in the pedal assembly.
2. Seat the cable retainer in the pedal assembly.
3. Engage the cable ball end in clevis on the pedal assembly.
