RAM 2500 Truck 2WD V10-8.0L VIN W (2003)
1. Check the gasket for use in head cover installation. If damaged, use a new gasket.
2. Install the gasket onto the head rail. For the left side the number tab is at the front of engine with the number up. For the right side the number tab
is at the rear of engine with the number up.
CAUTION: The cylinder head cover fasteners have a special plating. DO NOT use alternative fasteners.
3. Position the cylinder head cover onto the gasket. Install the stud bolts and hex head bolts in the proper positions (Fig. 12). Tighten the stud bolts
and the bolts to 16 Nm (144 in. lbs.) torque.
4. If removed, install the upper intake manifold.
5. Install closed crankcase ventilation system and evaporation control system onto the proper head cover. DO NOT switch the systems.
6. Connect the negative cable to the battery.
7. Start engine and check for leaks.
