RAM 2500 Truck 2WD V10-8.0L VIN W (2003)
Evaporator Core: Service and Repair
REMOVAL
WARNING: REVIEW THE WARNINGS AND CAUTIONS IN THE FRONT OF THIS SECTION BEFORE PERFORMING THE
FOLLOWING OPERATION.
1. Remove the HVAC housing from the vehicle, and disassemble the housing halves. Refer to Housing Assembly HVAC/ Service and Repair/
Procedures.
Fig. 7 Dual Zone HVAC Housing - (Typical Single Zone)
2. Lift the A/C evaporator out of the HVAC housing.
INSTALLATION
1. Insert the evaporator coil into the bottom of the HVAC housing. Make sure that the evaporator drain is clean and unrestricted and evaporator
deflector shield is also installed.
2. Reassemble and reinstall the HVAC housing in the vehicle. Refer to Housing Assembly HVAC/ Service and Repair/ Procedures.
NOTE: If the evaporator is replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system.
