RAM 2500 Truck 2WD V10-8.0L VIN W (2003)
Accelerator Pedal Position Sensor: Service and Repair
ACCELERATOR PEDAL POSITION SENSOR
REMOVAL
Fig.2 Apps Location
The APPS is serviced (replaced) as one assembly including the sensor, plastic housing and cable. The APPS assembly is located under the vehicle
battery tray. Access to APPS is gained from over top of left / front tire.
1. Disconnect negative battery cable at battery.
2. Disconnect APPS cable at accelerator pedal. Refer to Accelerator Pedal Removal/Installation.
3. Remove wheel house liner at left / front wheel. Refer to Body.
