RAM 2500 Truck 2WD V10-8.0L VIN W (2003)
Fuel Tank Unit: Service and Repair
REMOVAL
WARNING: THE FUEL SYSTEM IS UNDER A CONSTANT PRESSURE (EVEN WITH THE ENGINE OFF).BEFORE SERVICING THE
FUEL PUMP MODULE, THE FUEL SYSTEM PRESSURE MUST BE RELEASED.
1. Drain and remove fuel tank. Refer to Fuel Tank Removal/Installation.
Fig.15 Fuel Pump Module (Top)
Fig.16 Locknut Removal/Installation - Typical
2. The plastic fuel pump module locknut (Fig. 15) is threaded onto fuel tank. Install Special Tool 6856 to locknut and remove locknut (Fig. 16). The
fuel pump module will spring up slightly when locknut is removed.
3. Remove module from fuel tank.
INSTALLATION
CAUTION: Whenever the fuel pump module is serviced, the rubber gasket must be replaced.
