RAM 2500 Truck 2WD V10-8.0L VIN W (2003)
Throttle Position Sensor: Service and Repair
Fig.60 TPS Mounting Bolts - 8.0L V-10
REMOVAL 8.0L V-10
The TPS is located on the side of the throttle body.
1. Remove air plenum.
4. Disconnect TPS electrical connector.
5. Remove two TPS mounting bolts.
6. Remove TPS from throttle body.
Fig.63 TPS Installation - 5.9L V-8 And 8.0L V-10
INSTALLATION
The throttle shaft end of the throttle body slides into a socket in the TPS. The TPS must be installed so that it can be rotated a few degrees. If the sensor
will not rotate, install the sensor with the throttle shaft on the other side of the socket tangs. The TPS will be under slight tension when rotated.
1. Install the TPS and two retaining bolts.
