RAM 2500 Truck 2WD V10-8.0L VIN W (2003)
Manifold Pressure/Vacuum Sensor: Service and Repair
REMOVAL
Fig.38 MAP Sensor Location - 8.0L V-10
The MAP sensor is mounted into the right upper side of intake manifold. A rubber gasket is used to seal sensor to intake manifold. The rubber gasket is
part of sensor and is not serviced separately.
1. Remove electrical connector at sensor.
2. Clean area around sensor before removal.
3. Remove two sensor mounting bolts.
4. Remove sensor from intake manifold.
INSTALLATION
The MAP sensor is mounted into the right upper side of intake manifold. A rubber gasket is used to seal sensor to intake manifold. The rubber gasket is
part of sensor and is not serviced separately
1. Check condition of sensor seal. Clean sensor and lubricate rubber gasket with clean engine oil.
2. Clean sensor opening in intake manifold.
3. Install sensor into intake manifold.
4. Install sensor mounting bolts. Refer to Torque Specifications.
5. Install electrical connector to sensor.
