RAM 2500 Truck 2WD V10-8.0L VIN W (2003)
Power Distribution Relay: Service and Repair
Relay
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the relay by grasping it firmly and pulling it straight out from its receptacle. A slight back and fourth rocking motion may help the
removal process.
INSTALLATION
1. Position the relay to the proper receptacle.
2. Align the relay terminals with the terminal cavities in the receptacle.
3. Push firmly and evenly on the top of the relay until the terminals are fully seated in the terminal cavities in the receptacle.
4. Connect the negative battery cable.
