RAM 2500 Truck 2WD V10-8.0L VIN W (2003)
Main Relay (Computer/Fuel System): Description and Operation
AUTOMATIC SHUT DOWN RELAY
PCM OUTPUT
The 5-pin, 12-volt, Automatic Shutdown (ASD) relay is located in the Power Distribution Center (PDC). Refer to label on PDC cover for relay
location.
The ASD relay supplies battery voltage (12+ volts) to the fuel injectors and ignition coil(s). With certain emissions packages it also supplies 12-volts
to the oxygen sensor heating elements.
ASD SENSE - PCM INPUT
A 12 volt signal at this input indicates to the PCM that the ASD has been activated. The relay is used to connect the oxygen sensor heater element,
ignition coil and fuel injectors to 12 volt + power supply.
This input is used only to sense that the ASD relay is energized. If the Powertrain Control Module (PCM) does not see 12 volts at this input when the
ASD should be activated, it will set a Diagnostic Trouble Code (DTC).
