RAM 2500 Truck 2WD V10-8.0L VIN W (2003)
1. Place gasket in position on back of governor body (Fig. 84).
2. Place governor body in position on valve body
3. Install bolts to hold governor body to valve body
4. Lubricate O-ring on pressure sensor with transmission fluid.
5. Align pressure sensor to bore in governor body
6. Push pressure sensor into governor body
7. Lubricate O-ring, on pressure solenoid, with transmission fluid.
8. Align pressure solenoid to bore in governor body (Fig. 85).
9. Push solenoid into governor body
