RAM 2500 Truck 2WD V10-8.0L VIN W MDC (1999)
Cruise Control Servo Cable: Service and Repair
Servo Cable At Throttle Body
REMOVAL
1. Disconnect negative battery cable at battery.
2. Using finger pressure only, remove speed control cable connector at bellcrank by pushing connector off the bellcrank pin. DO NOT try to pull
connector off perpendicular to the bellcrank pin. Connector will be broken.
3. Squeeze 2 tabs on sides of speed control cable at throttle body mounting bracket (locking plate) and push out of bracket.
4. Remove servo cable from servo. Refer to Speed Control Servo Replacement.
INSTALLATION
1. Install end of cable to speed control servo. Refer to Speed Control Servo Replacement.
2. Install cable into throttle body mounting bracket. Cable snaps into bracket.
3. Install speed control cable connector at throttle body bellcrank pin. Connector snaps onto pin.
4. Connect negative battery cable to battery.
5. Before starting engine, operate accelerator pedal to check for any binding.
