RAM 2500 Truck 2WD V10-8.0L VIN W MDC (1999)
a brass or heavy plastic hammer to ensure locks have been seated.
8. If valves and/or seats were ground, measure the installed height of springs. Make sure the measurement is taken from bottom of spring seat in
cylinder head to the bottom surface of spring retainer. If spacers are installed, measure from the top of spacer. If height is greater than 42.86 mm
(1-11/16 inches), install a 1.587 mm (1/16 inch) spacer in head counterbore. Ensure this brings spring height back to normal, 41.27 to 42.86 mm
(1-5/8 to 1-11/16 inch).
