RAM 2500 Truck 2WD V10-8.0L VIN W MDC (1999)
Turn Signal Flasher: Service and Repair
Junction Block
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the fuse access panel by unsnapping it from the driver side end of the instrument panel.
3. Remove the combination flasher from the junction block.
INSTALLATION
1. Position the combination flasher in the proper receptacle in the junction block.
2. Align the combination flasher terminals with the terminal cavities in the junction block receptacle.
3. Push in firmly on the combination flasher until the terminals are fully seated in the terminal cavities in the junction block receptacle.
4. Install the fuse access panel by snapping it into the driver side end of the instrument panel.
5. Reconnect the battery negative cable.
