RAM 2500 Truck 2WD V10-8.0L VIN W MDC (1999)
retainer ring into fitting. With plastic ring depressed, pull fitting from component. The plastic retainer ring must be pressed squarely into fitting
body. If this retainer is cocked during removal, it may be difficult to disconnect fitting. Use an open-end wrench on shoulder of plastic retainer
ring to aid in disconnection.
5. After disconnection, plastic retainer ring will remain with quick-connect fitting connector body.
6. Inspect fitting connector body, plastic retainer ring and fuel system component for damage. Replace as necessary.
7. Prior to connecting quick-connect fitting to component being serviced, check condition of fitting and component. Clean parts with a lint-free cloth.
Lubricate with clean engine oil.
8. Insert quick-connect fitting into component being serviced until a click is felt,
9. Verify a locked condition by firmly pulling on fuel tube and fitting (15-30 lbs.).
10. Connect negative battery cable to battery.
11. Start engine and check for leaks.
Latch Clip Removal
LATCH CLIP FITTING (FUEL LINE-TO-FUEL RAIL)
A tethered latch clip is used to secure the fuel line to the fuel rail. A special tool will be necessary to separate fuel line from fuel rail after latch clip is
removed. This same latch clip may also be used to secure other different fuel system components.
CAUTION: The interior components (O-rings, spacers, retainers) of this type of quick-connect fitting are not serviced separately. Do not attempt to
repair damaged fittings or fuel lines/tubes. If repair is necessary, replace the complete fuel tube assembly.
WARNING: THE FUEL SYSTEM IS UNDER A CONSTANT PRESSURE (EVEN WITH THE ENGINE OFF). BEFORE SERVICING
ANY FUEL SYSTEM HOSES, FITTINGS OR LINES, THE FUEL SYSTEM PRESSURE MUST BE RELEASED. REFER TO THE FUEL
SYSTEM PRESSURE RELEASE PROCEDURE.
DISCONNECTION/CONNECTION
1. Perform fuel pressure release procedure. Refer to Fuel Pressure Release Procedure.
2. Disconnect negative battery cable from battery.
3. Clean fitting of any foreign material before disassembly.
4. Pry up on latch clip with a screwdriver.
5. Slide latch clip toward fuel rail while lifting with screwdriver.
Fuel Line Disconnection
