RAM 2500 Truck 2WD V8-5.2L VIN Y (2000)
Cruise Control Servo Cable: Service and Repair
Speed Control Switches
REMOVAL
1. Disconnect negative battery cable at battery.
2. Remove air cleaner.
Cable Connection at Throttle Body
3. Using finger pressure only, remove speed control cable connector at throttle body bellcrank by pushing connector off the bellcrank pin. DO NOT
try to pull connector off perpendicular to the bellcrank pin. Connector will be broken.
4. Squeeze 2 tabs on sides of speed control cable at throttle body mounting bracket (locking plate) and push out of bracket.
5. Remove servo cable from servo. Refer to Speed Control Servo Removal/installation.
INSTALLATION
1. Install end of cable to speed control servo. Refer to Speed Control Servo Removal/installation.
2. Install cable into throttle body mounting bracket. Cable snaps into bracket.
3. Install speed control cable connector at throttle body bellcrank pin. Connector snaps onto pin.
4. Connect negative battery cable to battery.
5. Before starting engine, operate accelerator pedal to check for any binding.
