RAM 2500 Truck 2WD V8-5.2L VIN Y (2000)
Cruise Control Vacuum Reservoir: Service and Repair
The vacuum reservoir is located under the plastic cowl plenum cover at lower base of windshield. The vacuum reservoir is not used if equipped with a
diesel engine.
REMOVAL
1. Disconnect and isolate battery negative cable.
2. Remove both windshield wiper arm/blade assemblies. Refer to Wiper and Washer Systems.
Cowl Grille Panel Weather-strip
3. Remove rubber weather-strip at front edge of cowl grill.
Plastic Anchor Screws Remove/Install
4. Release cowl grill plastic anchor screws.
5. Lift cowl plenum cover/grille panel from vehicle far enough to access vacuum reservoir.
