RAM 2500 Truck 2WD V8-5.2L VIN Y (2000)
INSTALLATION
1. If installing the blower motor wheel only, press the blower wheel hub onto the blower motor shaft. Be sure the flat on the blower motor shaft is
indexed to the flat on the inside of the blower wheel hub.
2. Install the retainer clip over the blower wheel hub. The ears of the retainer clip must be indexed over the flats on the blower motor shaft and
blower wheel hub.
Blower Motor Seal
3. Be certain that the blower motor seal is installed on the blower motor housing.
4. Install the blower motor and wheel assembly, and cover in the heater-A/C housing with three mounting screws. Tighten the mounting screws to 2.2
Nm (20 in. lbs.).
5. Plug the blower motor wire harness connector into the heater-A/C housing wire harness.
6. Install the blower motor wire harness into the wire harness retainer.
7. Connect the blower motor cooling tube to the nipple on the blower motor housing.
8. Connect the battery negative cable.