RAM 2500 Truck 2WD V8-5.2L VIN Y (2000)
1.
Flash the controller using the MDS2 (Mopar Diagnostic System) and DRBIII(R)
NOTE:
DUE TO THE PCM REPROGRAMMING PROCEDURE, A DTC MAY BE SET IN OTHER MODULES (EATX, BCM, MIC, SKIM, ETC.)
WITHIN THE VEHICLE, IF SO EQUIPPED. SOME DTC'S MAY CAUSE THE MIL TO ILLUMINATE.
ALL DTC'S RELATE TO A LOSS OF COMMUNICATIONS WITH THE MODULE THAT IS BEING REPROGRAMMED. CHECK ALL
MODULES, RECORD THE FAULTS, AND ERASE THESE FAULTS PRIOR TO RETURNING THE VEHICLE TO THE CUSTOMER. ERASE
ANY FAULTS IN THE PCM ONLY AFTER ALL OTHER MODULES HAVE HAD THEIR FAULTS ERASED.
NOTE:
THE FOLLOWING STEPS ARE REQUIRED BY LAW.
2.
Type the necessary information on the "Authorized Software Update Label" p/n 04669020 (Fig. 1). Attach the label to the PCM and cover the
label with the clear plastic overlay.
3.
Type the necessary information on the "Authorized Modification Label" p/n 04275086 and attach the label near the VECI label (Fig. (STEP # 3)).
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
