RAM 2500 Truck 2WD V8-5.2L VIN Y (2000)
High Rate
-
Key in Ignition Warning ignition OFF, key in ignition, drivers door open
-
Ignition OFF, headlamps ON, drivers door open Low Rate
-
Seat belt warning--6 seconds after key ON (6 to 8 chimes) or until belt is buckled
-
Airbag lamp illuminated (3 times after prove-out)
-
Anti-lock lamp illuminated (2 chimes after prove- out if equipped)
-
Check engine lamp illuminated (2 chimes after prove-out)
-
Check gauges lamp illuminated (2 chimes)
-
Engine Temp High--when gauge enters red zone (2 chimes)
-
Low fuel - when fuel level reaches 1/8 tank (2 chimes)
-
Low washer fluid (2 chimes)
-
Wait to start (diesel only) (2 chimes)
-
Water in fuel (diesel only) ( 2 chimes)
If the ignition switch is turned to the run/start position and the driver's door is closed, then opened, the warning chime is defeated. This allows the
doors to be open without the warning chime constantly sounding. The CTM stays in this mode until the ignition switch is turned to the "OFF"
position, then normal function will be restored. (Highline CTM only).
Enhanced Accident Response (Highline CTM Only)
If the Airbag Control Module (ACM) deploys the airbags, a message is transmitted over the CCD bus to the CTM module to unlock the doors.
The interior lights will be turned ON 10 seconds after getting zero speed message on the CCD bus.
In addition to unlocking the doors, the lock feature will be disabled for a predetermined amount of time following the deployment. Once the
ignition key has been cycled to the "OFF" position, normal operation will resume. This is a programmable feature.
